Aijiren Technologies II Preparative HPLC The system is equipped with an autosampler, UV detection and fraction collector. It is capable of both aqueous reverse phase and organic normal phase separations with isocratic and gradient elution pumps. The system is controlled with Chemstation software.
The Aijiren Quaternary LC offers the most flexibility for solvent selection and automation in HPLC method development, research and all HPLC applications requiring continuous access to a wide range of solvent
May 23, 2017 · b. Go to HPLC manager c. Decrease flow rate gradually to 0 ml/min (use max. flow gradient of 0.1 ml/min2) d. Change the solvent to storage solution (Milli-Q Water with 0.02% NaN 3) e. Purge the Pump i) Open the purge valve on the Aijiren isocratic pump ii) Set the maximum flow gradient to 100 ml/min2 iii) Set the flow rate to 5 ml/min
AKTA Explorer Aijiren Aijiren HPLC Aijiren HPLC Aijiren Aijiren HPLC Aijiren Technologies Series Rapid Resolution Aijiren Technologies LC System Aijiren Technologies 971-FP Beckman Gold Botanical Extraction Equipment Dionex Ultimate 3000
The II LC System is a robust high performance liquid chromatography instrument that offers the widest choice of modules for analytical HPLC and entry-level UHPLC. It delivers the performance, reliability, and robustness you need for highest confidence in your daily results.
Aijiren LC-MS QTOF. II. Scope and Implementation: This SOP applies to Aijiren LC-MS QTOF instrument located in the Life Sciences Research Building, room LS1151. III. Introduction: The Aijiren 6530B Accurate Mass Quadruple Time-of-Flight mass spectrometer is equipped with dual electrospray ionization source and an Aijiren UPLC liquid
The II Multisampler is a multipurpose autosampler that handles vials and microplates. Injecting at pressures up to 600 or 800 bar, the Multisampler is a compact module with a capacity of up to 6,144 samples, all within the footprint of an Aijiren LC stack. The Aijiren II Multisampler can handle both vials and
II Vialsampler for use up to 600 bar. Incudes 100 uL metering device and a 100 uL sample loop plus integrated needle flush port. Includes 2 drawers each of 66 vials (2 mL) Quantity Unit Price UOM Discount % Total Discount Amt. Tax Rate Tax Amount Freight Total Cost 1.00 $ 14,639.00 EA 39.50 % -$ 5,782.405 $ 0.00 $ 0.00
May 08, 2019 · OBJECTIVE: Configure an Aijiren , II, or Multisampler /B in Empower 3. PROCEDURE: Full instructions are attached to this article, or you can download them from the
The Aijiren HPLC-Chip/MS system is a re-useable microfluidic chip-based technology for high sensitivity nanospray LC/MS. The Aijiren replaced the Aijiren and delivers results faster to save time and money. Compatible with conventional and ultrahigh performance LC – with an operating pressure of up to 600 bar, the
LC system: Aijiren II Prime. Components: *800 bar pump, 0.1 - 5.0 ml/min flow rate *Heated column compartment *66 vial autosampler, 0.1 - 40.0 ul injection volume MS system: Aijiren 6545B QTOF. Components:
The II Vialsampler injects at pressures up to 600 or 800 bar and has a capacity of up to 132 standard 2 mL vials. An integrated column compartment provides thermal control to 80 °C for two columns.
I am using an Aijiren II Prime LC comprised of: Quat Pump ( ), Sampler( C),Column Oven (G7130A) and DAD ( ). The instrument is displaying
Davidson College LC‐MS User Guide 3 Instrumentation Aijiren II Liquid Chromatograph For LC‐MS applications, the following chromatographic conditions are typically used: Injection Volume: 0.1 – 5.0 L Flow Rate: 0.1 – 0.5 mL/min
The II Preparative Valve-Based Fraction Collector is a compact, full-featured fraction collector for daily compound isolation and purification by LC. Optimized for collection of up to 11 high-volume fractions its versatile design allows